HI Stick – PU Foam Dolphin

Application Instructions:
Shake Can vigorously for 45-60 seconds before and between uses
To avoid wastage or clogged nozzle, utilize the product within 2 hours of opening the Can
Make sure the application surface is free from dirt and grease. Also, Protect adjacent surface with tape and plastic film
Remove the seal cap from the Can and put a clean spray nozzle
Hold the cylinder upside down and dispense slowly. For a small gap, dispense PU Foam and fill the gap about 50%. Allow it to expand
Apply multiple layers if needed. Sprinkle a small amount of water on the first layer and leave it for 10 minutes to be cured. Apply the second layer and repeat the process.
Recommended single layer thickness is 5-8cm
Wait for a minimum of 1 hour before performing the next step
Use a knife to remove/trim excess foam
If the layer thickness is more than 15cm; curing time is 12 hours
PU Foam drops/Stains can be cleaned with paint thinner acetone or toluene
For best result, apply it within defined temperature (From 5°C to 30°C)
CFC and HCFC FREE
Safety Measures:
Always keep the Can in an upright position
Do not expose it to sunlight and temperature exceeding 50°C
Do not pierce or burn Can even after uses
Extremely flammable. No smoking during the application
Use protective gloves, glasses and face protectant while applying
First AID Treatment:
Remove contaminated clothing and wash skin with soap and water. In case of contact with eyes, splash water into the eyes to remove the chemicals. Upon inhalation, leave the area to get fresh air. If swallowed, drink fluid in large quantity and consult the physician immediately.

FULLY CURED DOLPHIN PU FOAM IS NOT HARMFUL TO HEALTH

KEEP OUT OF REACH OF CHILDREN

Packaging:
400ml - LP008
750ml - LP007